![]() ![]() Edit the wirepath using Change at a point.Ĭreate Rectangle. Create Thread Point.Ĭontour wirepath to cut a die with taper angle and land. Windows 7 and Windows 8 are registered trademarks of Microsoft Corporation. Microsoft, the Microsoft logo, MS, and MS-DOS are registered trademarks of Microsoft Corporation N-See is a registered trademark of Microcompatibles, Inc. Trademarks Mastercam is a registered trademark of CNC Software, Inc. ![]() This document may not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic medium or machine readable form without prior consent, in writing, from In-House Solutions Inc. Copyrights This manual is protected under International copyright laws. ![]() Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for incidental or consequential damages, so the above limitation or exclusion may not apply to you. has been advised of the possibility of such damages. be liable for direct, indirect, or consequential damages resulting from any defect in the manual, even if In-House Solutions Inc. Should the manual prove defective following its purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire cost of all necessary servicing, repair, of correction and any incidental or consequential damages. manual is sold or licensed "as is." The entire risk as to its quality and performance is with the buyer. makes no warranties, either express or implied, with respect to this manual or with respect to the software described in this manual, its quality, performance, merchantability, or fitness for any particular purpose. Disclaimer Of All Warranties And Liability In-House Solutions Inc. reserves the right to make improvements to this manual at any time and without notice. All rights reserved Software: Mastercam X7 Author: Mariana Lendel ISBN: 978-1-92 Date: June 12, 2013 Mastercam X7 Wire Training Tutorial Copyright: 1998 - 2013 In-House Solutions Inc. To order more books: Call 1-80 or Visit or Contact your Mastercam dealer ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |